Setting axlink and prolink address numbers, Lighting application drawing – AMX Control Card RDC-DC User Manual
Page 2
AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
043-019-2242 8/01 ©2001 AMX Corporation. All rights reserved.
The AMX logo is a trademark of AMX Corporation. AMX Corporation reserves the right to alter specifications without notice at any time.
3000 research drive, richardson, TX 75082 USA • 469.624.8000 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993
Setting AXlink and PROlink Address Numbers:
Lighting Application Drawing
Dry Closure Default Presets
Contact Closure
Default Function
1
Channel 1 at 100% in 1 second
2
Channel 2 at 100% in 1 second
3
Channel 3 at 100% in 1 second
4
Channel 4 at 100% in 1 second
5
Channel 5 at 100% in 1 second
6
Channel 6 at 100% in 1 second
7
Pack on (channels 1-6)
8
Pack off (channels 1-6
All other channels are undefined.
FIG. 6 Setting AXlink and PROlink address numbers.
AXlink Address
PROlink Address
Test
Set the AXlink address number
(1-255) for the RDC-DC. This
number must match the device
number in your Axcess program.
Use the PROlink DIP switch to set
the PROlink address number for the
RDC-DC (1-10).
Pin 8 on the PROlink DIP switch is
a test switch that turns all circuits on
to full.
F1
RDC-DC/120
Panel
All neutrals are common to the Neutral
block in the enclosure. Provide a separate
neutral for each load.