AEG L60460FL - Manual (Page 35)

• On the edge of a sink.
• Make sure that the plastic guide can-
not move when the appliance drains.
Attach the guide to the water tap or
the wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into
a drain pipe at a height of not less
than 60 cm (23.6”) and not more than
100 cm (39.3”). The end of the drain
hose must always be ventilated , i.e.
the inner diameter of the drainpipe
(min. 38 mm — min. 1.5”) must be
larger than the external diameter of
the drain hose.
• If the end of the drain hose is this
(see the drawing), you can push it di-
rectly into the stand pipe.
Without the plastic hose guide.
• To a sink spigot.
Refer to the illustration. Put the drain
hose in the spigot and tighten it with
a clip. Make sure that the drain hose
makes a loop to prevent that remain-
ing particles go in the appliance from
the sink.
ENGLISH
35