Technical support – Airlink101 AWLH6045 User Manual
Page 5
Section 4
Step 4
The utility will detect the encryption settings of your wireless router or
access point and show it in the boxes below automatically. If you do not have any
encryption settings, you will not see this window. After selecting the proper
encryption settings from the drop-down menu, click Next.
Step 8
Verify that you are receiving adequate Signal Strength and Link Quality and
that you have been assigned a valid IP address (instead of all 0’s).
Step 5
Follow the on-screen instructions to enter the encryption key values. Click
Complete when finished.
Step 6
You should see a blue circle around the antenna icon indicating a valid
connection.
Step 7
Go to the Link Information tab and click on the More button.
Technical Support
*Theoretical maximum wireless signal rate derived from IEEE 802.11g standard and IEEE 802.11n draft specification version 1.0. Actual data
throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, mix
of wireless products used, radio frequency interference (e.g., cordless telephones and microwaves) as well as network overhead lower actual
data throughput rate. Specifications are subject to change without notice. All products and trademarks are the property of their respective
owners. Copyright ©2006 AirLink101™
E-mail: [email protected]
Toll Free: 1-888-746-3238
Web Site: www.airlink101.com
Section 3