AEG L98699FL - Manual (Page 16)

8. SETTINGS
8.1 Acoustic signals
You can hear the acoustic signals when:
• You activate the appliance.
• You deactivate the appliance.
• You touch the buttons.
• The programme is completed.
• The appliance has a malfunction.
To deactivate/activate the acoustic
signals, press Stains/Prewash and Extra
Rinse at the same time for 6 seconds.
If you deactivate the
acoustic signals, they
continue operate only when
you touch the buttons and
when a malfunction occurs.
8.2 Child Lock function
With this function you can prevent that
the children play with the control panel.
• To activate/deactivate this function,
touch Temp. and Spin buttons at the
same time until the indicator
comes on/goes off.
You can activate this function:
• After you touch Start/Pause : all the
buttons and the programme knob are
deactivated.
• Before you touch Start/Pause : the
appliance cannot start.
8.3 Permanent Extra Rinse
With this function you can keep the extra
rinse permanently on when you set a new
programme.
• To activate/deactivate this function
touch Time Save and Delay Start at
the same time until the display show
the indicator
comes on/goes
off.
9. BEFORE FIRST USE
1. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
2. Put a small quantity of detergent in
the compartment for washing phase.
3. Set and start a programme for cotton
at the highest temperature without
laundry.
This removes all possible dirt from the
drum and the tub.
9.1 Language setting
The first time you activate the appliance,
the display shows the default language
and tells you to confirm it or change it:
1. Turn the programme knob to set the
desired language.
2. When the display shows the
necessary language touch Start/
Pause button to confirm the
selection.
9.2 Change the language after
the first activation
1. Touch button Spin and button
Stains/Prewash at the same time for
some seconds.
2. When the display shows the
language set, turn the programme
knob to set the new language.
3. Touch Start/Pause button to confirm
the selection.
9.3 Clock setting
After you set the language, the display
tells to set the clock. The hour digits
flash.
1. Turn the programme knob to change
the hour.
2. Touch Start/Pause button to confirm
the selection.
The minute digits flash.
3. Turn the programme knob to change
the minutes.
www.aeg.com 16