Section 1, Introduction, 1 features – Atmel AT89STK-06 User Manual
Page 3: Section 1 introduction -1, Features -1
AT89STK-06 Demo Board Software Demonstration Guide
1-1
Rev. 4339C–CAN–07/05
Section 1
Introduction
This document describes the board included in the AT89STK-06 Starter Kit dedicated to
the T89C51CC01/CC02 and AT89C51CC03 CAN microcontrollers (for T89C51CC02
optionnal adaptor is required). This board is designed to allow an easy evaluation of the
product using demonstration software.
The AT89STK-06 Starter Kit can be used with the AT89C51AC3, TR89C51AC2, and
T89C5115 Flash Microcontrollers with ADC (for T89C5115 optional adapter is required).
1.1
Features
•
CAN
– On board CAN transceiver Atmel ATA6660
– D-sub Connector Compliant to the CiA (User Group: "CAN in Automation")
Recommendation for the CAN High Speed Bus
•
Two Different Sockets to Support AT89C51CC03 and AT89C51AC3 in PLCC52 and all
controllers in PLCC44 Packages
•
Support of the T89C51CC02 & T89C5115 Microcontroller Requires the use of a PLCC28
Adapter (CANADAPT28).
•
The Board Comes with a AT89C51CC03-UA (PLCC44 package) and a AT89C51CC03-CA
(PLCC52 package) Samples
(1)
.
•
Analog-to-Digital Converter
– Potentiometer
– Thermal Resistor
– On board ADC Reference Voltage
•
On-board Reset, INT0, INT1, LEDs, EA, ISP and Programming Interface
•
Power, ALE, RS232 Rx and Tx LEDs
•
CAN, SPI and RS232 Hardware Connectors
•
On-board Voltage Regulator
•
Voltage Operation: 8V to 15V
•
Operating Temperature Range: 0 to +70
°C
•
Dimension: 80 mm x 100 mm
Notes: 1.
Samples for AT89C51AC3, T89C51CC01, T89C51AC2, T89C51CC02, and
T89C5115 can be ordered separately