Nilfisk-ALTO DPA 2500 - Manual (Page 8)

4.3 Channel Selection
There are total 3 options available (CH1, CH2, CH1+CH2), you can apply these effect settings on either or
channels. both selected
Select "CHSEL" using SELECT key, the "CHSEL" indicator lights up and the last selected channel will be displayed.
Use UP or DOWN key to select either or both channels.
Press ENTER key to confirm your selection.
- Hum Cancel (ON/OFF)
Select "EDIT" using SELECT key.
Then select "HUM CANCEL" using UP/DOWN keys, both the "HUM CANCEL" and "EDIT" indicators will light
up.
Press "ENTER" to set Hum Cancel function ON or OFF.
Note: the HUM CANCEL indicator will be lighting all the time if you set this function ON, and it effects only on
selected channels. the
- Noise Gate (ON/OFF)
Select "EDIT" using SELECT key.
Then select "NOISE GATE" using UP/DOWN keys, both the "EDIT" and "NOISE GATE" indicators will light
up.
Press ENTER key to set Noise Gate ON or OFF.
Note: the NOISE GATE indicator will be lighting all the time if you set this function ON, and it effects only on
the selected channels.
- Multicomp (ON/OFF)
Select "EDIT" using SELECT key.
Then select "MULTICOMP" using UP/DOWN keys, both the "EDIT" and "MULTICOMP" indicators will light
up.
Press "ENTER" to turn the Multiband compressor ON or OFF.
Note: this indicator will be lighting all the time if you set this function ON, and it effects only on the selected channels.
4.4 Comm Selection:
It sets the ID number of the unit (1 in the default condition, 32 available).
be Select "COMM" using SELECT key, the "COMM" indicator lights up and the last selected ID number will
displayed.
Use UP/DOWN keys to set the new ID number.
Press ENTER key to confirm the new ID number.
4.5 SIG/LIMITER LED
The LED shows yellow when there is signal present.
The LED shows red when the signal is limited, it indicates that the signal is too strong and possibly distorted.
7
5. REMOTE CONTROL
To operate one or more DPA units that are connected to a PC, you need to download a Windows compatible MAXI
EDITOR program from our website. To get a copy, please go to www.altoproaudio.com http:// /html/download.php.
IMPORTANT!!!
In Remote Control mode, the panel controls of UP, DOWN, SELCTOR and ENTER will be disabled.
5.1 How to set the DPA's ID number
In order to be recognized from the MAXI EDITOR program, each DPA connected to the PC must have an ID
number.
Select the COMM menu with the SELECT button, the display will show the current ID number of the unit.
Use the UP/DOWN keys to select the ID number.
IMPORTANT!!!
When several DPA are connected to a PC for the remote control, each of units must have an ID number
different from all the others. If two or more units have the same ID number, they won't be recognized by the
PC.