AEG HTD 5616 - Manual (Page 21)

English
21
WARNING:
• This appliance may be used by children aged from 8 years up
and by persons with reduced physical, sensory, or mental ca-
pabilities or lack of experience and knowledge proved they
do so under supervision or have been given instructions on
how touse the appliance safelyand understand the hazards
involved.
• Children must not play with the appliance.
• Cleaning and user maintenance must not be carried out by
children, unless they are supervised.
• The nozzles become hot during operation!
• If the hair dryer is used in the bathroom, disconnect it from the
mains after use as nearby water presents a hazard. This also ap-
plies if the appliance is switched off.
• Please ensure that the inlet grille remains free of fluff and hairs.
Danger of fire!
• As additional protection we recommend the installation of a
fault current protection device (FI/RCD) with a rated current of
not more than 30 mA in the wiring system of the bathroom.
Please contact an authorised electrician for advice.
Use
1. Turn the appliance on with the bottom switch on the
handle.
2. Select an air stream level on the handle (bottom switch):
Position 0: off
Position : gentle stream of air
Position : strong stream of air
3. Setting the Temperature level (top switch):
Position : low temperature
Position : Eco: Environmentally friendly energy
saving setting, medium temperature for
gentle drying and shaping.
Position : high temperature for rapid drying.
Commissioning
1. Applicare eventualmente un ugello.
• You can dry single hair locks by concentrating the
flow of hot air with the hairdressing nozzle.
• The diffuser is the ideal solution to dry curly hair
without losing volume.
2. In order to replace the attachment, first remove the old
attachment by pulling it off and then pushing on the new
one until it clicks into place.
Electrical Connection
• Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
• Connect the device to a duly installed protective contact
socket.