AMX Modero NXD/NXT-1200VG - Manual (Page 47)

Touch Panel Accessories
33 VG-Series Modero Touch Panels
Step 2: Install the 802.11g mini-PCI Wireless Card
1. Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the mini-PCI card connector on the main board (FIG. 16 and FIG. 17).
3. Carefully remove the gold-tipped terminal ends of the antenna from their factory default connectors on
the main board. The antenna is secured at this location to restrict its movement prior to connection to a
wireless card.
4. Firmly grasp the NXA-PCI80211G mini-PCI card (from the edges) and insert the pins (at a 25° angle)
into the opening on the connector (FIG. 18).
5. While maintaining the 25° angle alignment on the new module, push it in firmly until the contact pins are
completely inside the connector and the card "snaps" into place (FIG. 18).
6. Push the card downward (to the main board) until the side braces snap atop the NXA-PCI80211G and
hold it in place.
FIG. 16 Location of the NXA-PCI80211G wireless card on the NXT board
FIG. 17 Location of the mini-PCI card connector on main board
I/O connector
Compact Flash card
Outer Housing
plate
Eight Housing
Screws
NXA-PCI80211G
wireless card
location
If you have previously installed an NXA-RGB card, it must first be removed prior to
gaining access to the mini-PCI connector on the board.