AMX Modero NXD/NXT-1200VG - Manual (Page 59)

Installation Procedures: 12" and 15" Panels
45 VG-Series Modero Touch Panels
Installation Procedures: 12" and 15" Panels
Overview
NXT panels are mounted onto flat (horizontal) surfaces in either a stand-alone or combo (NXT atop an NXA-
BASE/B battery base) configuration. NXD panels are installed into either a pre-wall surface (using a CB-
TP12/CB-TP15 conduit/wallbox) or a solid surface (using either solid surface or drywall screws).
Unpacking the Panel
1. Inspect and confirm the contents of the shipment box to verify that you have all specified parts. Refer to
the Specifications sections on page 2 and page 5 for more information about included accessories and
other AMX equipment.
2. Carefully remove the panel from the shipping box.
3. Carefully peel the protective plastic cover from the LCD.
Installing Internal Components
Installation of the internal components such as the NXA-PCI80211G Wireless card and NXA-RGB Interface
card are described in detail within the following sections:
 Step 2: Install the 802.11g mini-PCI Wireless Card section on page 33.
 Step 3: Install the NXA-RGB Card Component (NXT) section on page 34.
Upgrading to the MB-TP12/MB-TP15 VESA Mounting Kit
Upgrading the existing back box with the new VESA Mounting Kit on both the 12" (FG031-50) and
15" panel (FG032-50) is identical and requires 3 main processes:
 Removing the pre-existing back box and installing the new VESA back box.
 Threading cables through the strain relief grommet opening in the rear plastic cover.
 Finalizing the installation of the NXD (with VESA back box and cables) into the plastic cover,
securing both components, and finalizing the strain relief grommet installation.
Removing the Original Modero Back Box
1. Detach all connectors from the side of the touch panel.
2. Remove the magnetic faceplate from the NXD unit by gripping the faceplate and pulling outwards while
applying a small amount of pressure to remove it from the main unit.
3. Place the LCD face-down on a soft cloth to expose the back of the panel and prevent scratching of the
LCD.
4. Unscrew the Stereo Output nut from the Stereo Output jack.
It is recommended that if you are planning on upgrading your panel components
(flash, wireless, RGB card), you do so before beginning any panel installations.
If the protective plastic LCD cover is not removed, the panel may not respond
properly to touch points on the LCD or allow proper screen calibration.
The installation procedures found in this section are identical for both sizes of panels
(12" and 15"). Only overall dimensions and FG product numbers are different.
The new MB-TP Universal VESA Mounting Box uses a standard VESA installation
pattern of 75 mm between holes. VESA mounts that conform to this pattern can be
used on the MB-TP Housing.