AEG X99384MD02 - Manual (Page 5)

5 ENGLISH
5. CONTROLS
The hood is fi tted with a control panel with
aspiration speed selection control
and a light switch to control cooking area
lights. Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes
prior to cooking and to leave in operation
during cooking and for another 15
minutes approximately after terminating
cooking.
+ 1 2 3 4
1 2 3 4 5 6
1. Lights ON/OFF
2. Motor ON/OFF
3. Motor speed decrease/Motor OFF
4. Motor increase/Motor ON
5. Extraction mode selection
Grease fi lter saturation indicator
6. Filtration mode selection
Carbon fi lter saturation indicator
The lighting of the corresponding symbol
indicates the type of extraction mode being
used:
by suction
by fi ltration
- The transition from one mode to
another must occur only with the motor
running.
- During the transition from one mode
to another, the motor will automatically
shut off, and then resume operation in
the previously set speed.
- Special functions:
Timed intensive function
Selecting the fourth speed, this remains
timed for 5 minutes, then the motor will
return to the second speed.
- Metal grease fi lters indicator reset
Every 40 hours of use, the system will
notify you, by fl ashing symbol 5 (motor
off), the need to clean the metal grease
fi lters.
To clear the warning message, after
cleaning the metal grease fi lters, press
and hold button 5 (motor off) for more
than 5 seconds; a beep will indicate the
reset has occurred.
- Carbon fi lters indicator reset
Every 160 hours of use, the system will
notify you, by fl ashing symbol 6 (motor
off), the need to replace carbon fi lters.
To clear the warning message, after
replacing the carbon fi lters, press and
hold button 6 (motor off) for more than 5
seconds; a beep will indicate the reset
has occurred.
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the
LED light.
For replacement, contact the technical
service.