AeroGarden 507140-0000 AD - Manual (Page 12)

Place Tray in AeroGarden
Remove Grow Surface from Bowl and set aside.
Lower Lamp Hood to lowest position.
Place Bowl on Base.
Add water up to “Fill to Here” inside Bowl.
Plug in AeroGarden.
Press “Select” button to set AeroGarden to
“Tomatoes/Peppers” on 7-Pod models,
and “Vegetables” on AeroGarden 6 and
Space•Saver 6 models.
Press and HOLD “Reset” button for 6 seconds
(Space•Saver 6 models), and 9 seconds (AeroGarden 6
and all 7-Pod models).
When “Add Nutrient” light begins to blink, release
“Reset” button. Nutrient timer is reset.
NOTE: In some cases, you may see other lights blink as
well. This is nothing to worry about.
To place planted Tray into AeroGarden:
• Carefully lift Tray from work surface. Keep Tray
steady to avoid spilling seeds from Grow Sponges.
• Gently lower Tray into Bowl so the large semi-circle
cutout for “Fill to Here” mark is in front.
NOTE: To inhibit algae growth, cover any empty Grow
Sponge Openings. (There is no need to cover
unplanted Grow Sponges.) A bottlecap, a cut-out
piece of plastic from a container lid or aluminum
foil all work well.
11
Setting Up Your AeroGarden
AeroGarden Classic shown
1
2
3
4
5
6
7
8
• Use room-temperature water. Very hot or very cold water will hurt your plants.
• We recommend using municipal tap, bottled or purified water. Well or softened water
SHOULD NOT be used because the extra minerals in these sources may be harmful to
aeroponically grown plants.
!