Aiwa NSX-AJ503 - Manual (Page 19)

19
En
Timer recording
Timer recording is available only for TUNER and VIDEO/AUX
(with an external timer) sources.
1 Press either TUNER/BAND or VIDEO/AUX to
select a source.
2 Press TIMER repeatedly until "5REC" appears
on the display.
3 Carry out step 3 to step 5 described in "Timer
playback".
4 Prepare the source.
To record the radio, select the band and tune in to the
desired station.
To record external equipment connected to the VIDEO/
AUX jacks, set an external timer for the equipment so that
its playback begins at the same time.
5 Insert the recording tape in DECK 2 and then turn
the unit off.
To display the timer setting
Press TIMER.
The timer-on time, the source and the timer-activated duration
are displayed for 6 seconds.
Tip:
Timer setting can be displayed even while the unit is turned
off, and at that time if you press ENTER or a within 6 seconds
after TIMER is pressed, you can enter the timer setting mode
and change the setting.
To change the timer setting
Re-set the timer again.
To cancel the timer
Press TIMER repeatedly until "
OFF" is displayed. "5"
disappears from the display.
Tip:
Your timer setting is retained even if the timer is canceled.
Next time the timer is activated, you can change your previous
setting, or simply use the same setting again.
01NSX-AJ500/AJ503(U)/Eng 12/22/00, 3:51 PM 19