AEG HC 5585 - Manual (Page 31)

English
31
Overview of the Components
1 Buttons for temperature adjustment
2 Display, backlit (blue, red, green)
3 On / off switch
Before Initial Use
• Remove all the packing materials.
• When the device is switched on for the first time there
may be a slight smell. You should therefore operate the
device for approximately 10 minutes without smoothing
your hair. Ensuring sufficient ventilation!
Commissioning
1. Fully unwind the mains cable.
2. Insert the plug in a duly installed socket.
3. Press the On/ Off switch to turn on the device.
NOTE:
• The device always starts with the previously selected
setting.
• The display shows the current temperature.
4. Select a temperature between 50°C and 200°C:
• With the “ “ button you can reduce the temperature
by 10°C each time.
• With the “ “ button you can increase the tempera-
ture by 10°C each time.
NOTE:
• The display lights up blue if you increase or decrease
the temperature.
NOTE:
• The display lights up red while the device is heating up
or cooling down.
• The display lights up green as soon as the set tempera-
ture is reached.
General Use
• Select the desired temperature as described above.
• The device must be used only for
dry hair.
• Take a strand of hair and pull it carefully downwards until
it is taut.
• The remaining hair should be put up or fixed in place.
• Before the halves are pressed together for approx.
5 seconds, we recommend that you ensure that the hair is
positioned correctly. Always begin at the base of the hair
and move the device in the direction of the hair tip.
• In order to produce a uniform appearance it is important
that the next strands fall in one line.
Switch-off
• Press the On/ Off switch to turn off the device.
• Remove the mains plug.
• Leave the device to cool before putting it away.
Place the device on its side.
Safety Switch-Off
This device features a safety switch-off. In case you forget to
switch the unit off after use, it automatically turns off approx.
60 minutes after the last time a button was pressed.
• Please follow the instructions as stipulated in the chapter “Clean-
ing and Care”.
Cleaning and Care
WARNING:
• Before cleaning remove the mains lead from the socket.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.