AEG S63300KDW0 - Manual (Page 30)

Problem Possible cause Solution
The room temperature is
too high. Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly. Refer to "Closing the door".
The ShoppingMode func-
tion is switched on. Refer to "ShoppingMode
function".
The compressor does not
start immediately after
pressing the Shopping-
Mode, or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows inside the refrig-
erator. The water outlet is clog-
ged. Clean the water outlet.
Food products prevent
that water flows into the
water collector. Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The FastFreeze or Shop-
pingMode function is
switched on. Switch off FastFreeze or Shop-
pingMode manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or
ShoppingMode function".
DEMO appears on the dis-
play. The appliance is in demon-
stration mode. Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tem-
perature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
www.aeg.com 30