AEG A72019GNW0 - Manual (Page 30)

WARNING!
It must be possible to disconnect
the appliance from the mains
power supply; the plug must
therefore be easily accessible af-
ter installation.
9.3 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
9.4 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
9.5 Door reversibility
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Remove the plinth.
• Unscrew and remove the lower hinges.
• Remove the door.
2
1
• Unscrew the upper pin and screw it on
the opposite side.
• Refit the door.
• Make sure the edge of the door is par-
allel with the edge of the top.
30 www.aeg.com