Operation, Service, Environment protection – AEG SKS51200F0 User Manual

Page 24: Switching on, Switching off, Temperature regulation

Advertising
background image

• Adequate air circulation should be around the appliance, lacking this leads to overheat-

ing. To achieve sufficient ventilation follow the instructions relevant to installation.

• Wherever possible the back of the product should be against a wall to avoid touching or

catching warm parts (compressor, condenser) to prevent possible burn.

• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the appliance.
• Connect to potable water supply only.

7)

Service

• Any electrical work required to do the servicing of the appliance should be carried out by

a qualified electrician or competent person.

• This product must be serviced by an authorized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses which could damage the ozone layer, in either its

refrigerant circuit or insulation materials. The appliance shall not be discarded together

with the urban refuse and rubbish. The insulation foam contains flammable gases: the ap-

pliance shall be disposed according to the applicable regulations to obtain from your local

authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchang-

er. The materials used on this appliance marked by the symbol are recyclable.

OPERATION

Switching on

Insert the plug into the wall socket.

Turn the Temperature regulator clockwise to a medium setting.

Switching off

To turn off the appliance, turn the Temperature regulator to the "O" position.

Temperature regulation

The temperature is automatically regulated.

To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings to obtain the minimum coldness.
• turn the Temperature regulator toward higher settings to obtain the maximum coldness.
A medium setting is generally the most suitable.

However, the exact setting should be chosen keeping in mind that the temperature inside

the appliance depends on:
• room temperature
• how often the door is opened

7) If a water connection is foreseen.

24

Operation

Advertising