Blaupunkt CR127 - Manual (Page 16)

16
Auxiliary Input Jack
Connect other audio equipment, such as a portable DAT player, through the 1.2 volt/3.5
mm pigtail connector. Access auxiliary equipment output by pressing SRC until “InP”
appears. Adjust volume, bass, and treble settings through head unit.
Troubleshooting Guide
The following check will assist in the correction of most problems which you may encounter with your
unit. Before going through the check list below, refer back to the connection and operating procedures.
General
Trouble Cause/Solution
No sound. • Adjust the volume with the + button.
• With a two-speaker system set the fader control to the center
position.
Radio reception
Trouble Cause/Solution*
Preset stations are not receivable. • The broadcast is too weak.
Automatic tuning is not possible. • The broadcast is too weak. —> Use manual tuning.
Travel Store feature does not complete • Not enough broadcast frequencies are receivable.
storing of six stations.
* Also make sure that antenna is connected, extended and dry inside.
If the above mentioned solutions do not help to improve the situation, consult your nearest Blaupunkt dealer or in
the United States call 1-800-266-2528.