Brother HL-P2000 - Manual (Page 28)

USER’S GUIDE
3-4
Test Print Mode
The machine has the following test print mode. Follow these steps:
1. Make sure that the top cover is closed.
2. Hold down the switch and turn on the power switch. Keep the
switch depressed until the Drum lamp comes on.
The Drum lamp lights to indicate that the machine is in the test print
mode.
3. Press the switch again to execute the test print or hold down the
switch to select another option and release the switch to execute the
selected option.
The test print modes are listed below:
Lamp Lit Choice Function
Drum Test sample page The machine prints a test sample page.
The machine returns to the ready status after
printing.
Alarm Print Config & Print
Fonts I The machine prints the current configuration of
the machine and a list of the internal fonts.
The machine returns to the ready status after
printing.
Ready Factory Reset The machine is restored to the factory setting
and permanent fonts and macros are cleared.
The machine returns to the ready status after
printing.
Data Hex Dump Print The machine can print data as hexadecimal
values, so that you can check data errors and
problems. To exit from this mode, you have to
turn off the machine.