AEG MSS 5572 - Manual (Page 45)

45
English
NOTE:
Serrated knives are only sharpened from one side.
1. Turn the guide cap with the symbol “knives with serrated blades” as far as the dot
on the device
2. Insert the teeth of the knife into the guide mechanism and sharpen them on the
grinding stone.
Then proceed as described under points 3 to 5 in the “Kitchen Knives” section.
Scissors
1. Open the blades of the scissors completely.
2. Hold the housing in your hand so that you can press the on/off button with your
thumb.
3. Turn the guide cap with the symbol “scissors” as far as the dot on the device.
4. Insert a blade into the scissor guide mechanism and pull the scissors towards you
at an even speed.
Please continue as described under “kitchen knives“.
Screwdrivers
Hold the housing in your hand so that you can press the on/off button with your
thumb.
1. Insert the end of the screwdriver either into the small or the large screw-driver
guide mechanism.
2. Please ensure that you have inserted the correct size of screwdriver into the guide
mechanism.
3. Press the On/Off button. You must keep the button pressed in this position.
CAUTION:
The device should not be used for more than three minutes at a time. Please allow
it to cool down for 30 minutes before using it again.
Take-up Mechanism for Mains Cable
The mains cable can be wound up around the base section.