Installation, Unpacking, Mounting guidelines – Briggs & Stratton 100 Amp Automatic Transfer Switch User Manual

Page 6: Déballage, Consignes d'installation, Unpacking mounting guidelines

Advertising
background image

6

BRIGGSandSTRATTON.COM

Installation

Unpacking

Delivery Inspection

After removing the carton, carefully inspect the transfer
switch components for any damage that may have occurred
during shipment.

IMPORTANT: If loss or damage is noted at time of delivery,
have the person(s) making delivery note all damage on the
freight bill and affix his signature under the consignor's
memo of loss or damage. If loss or damage is noted after
delivery, contact the carrier for claim procedures. Missing or
damaged parts are not warranted.

Shipment Contents

• Automatic Power Transfer Switch
• Installation and Operator’s Manual
• Current Transformers

Mounting Guidelines

The Automatic Transfer Switch is enclosed in a NEMA
Type 3R enclosure suitable for indoor/outdoor use.
Guidelines for mounting the Automatic Transfer Switch
include:

• Install the switch on a firm, sturdy supporting structure.
• The switch must be installed with minimum NEMA 3R

hardware for conduit connections.

• To prevent switch contact distortion, level and plumb the

enclosure. This can be done by placing washers between
the switch enclosure and the mounting surface.

• NEVER install the switch where any corrosive

substance might drip onto the enclosure.

• Protect the switch at all times against excessive moisture,

dust, dirt, lint, construction grit and corrosive vapors.

A typical installation of the Automatic Power Transfer Switch
is depicted below. An alternative installation of the Automatic
Power Transfer Switch is also depicted below. It is best if the
transfer switch is mounted near the utility meter, either
inside or outside. Discuss layout suggestions/ changes with
the owner before beginning the system installation process.

Main

Breaker

Panel

Transfer

Switch

Hot

Water

Heater

Air

Conditioner

Contactor

Service Disconnect

Generator

Watt -

Hourmeter

Branch Circuits

— — — — — — Control Wiring

Disconnect Switch

Typical

Main

Breaker

Panel

Transfer

Switch

Hot Water

Heater

Air

Conditioner

Contactor

Disconnect Switch

Generator

Watt -

Hourmeter

Branch Circuits

— — — — — — Control Wiring

Emergency

Load Center

Alternate

Advertising