Bissell 1960 - Manual (Page 7)

7
Pre-treat stubborn stains and highly soiled carpet in hallways and
other high-traffic areas.
Spray soiled area with BISSELL ® Tough Stain PreCleaner. ™
Use a stiff-bristled brush to work formula into carpet pile.
Wait 3 -5 minutes before deep cleaning.
Turn Power Switch [located on the side of the Lower
Body] to ( ) ON.
With foot, press the Detent Lever on right side of Lower Body.
Depress Spray Trigger to spray cleaning solution.
Do not overwet.
To suction up water, repeat motion over same area without
depressing Trigger.
Repeat Steps 3 and 4 until no more dirt can be removed.
Continue to clean entire carpet, working in 3’ x 4’ sections.
Empty the Dirty Water Tank when dirty water reaches the
full line, or when the Clean Water Tank is empty. See
page 9 for instructions.
If Floor Nozzle stops spraying, turn Power Switch to OFF
( ) and check water and cleaning solution levels. Refill
if needed.
Deep Cleaning
1.
2.
8.
Pre-Treating
1.
3.
Tip:
Deep cleaning
spots, spills
and high traffic
areas on a
regular basis can
prolong
carpet life.
3.
4.
5.
6.
7.
Tip:
It is recommended that
every time your Clean
Water Tank is emptied
of solution that you
empty the contents of
the Dirty Water Tank. If
the Dirty Water Tank
gets too full, you may
begin to see foam
spitting out of the vent
cover. When this
happens you will know
it is time to empty the
Dirty Water Tank.
Dirty Water Tank
7. Vent
Cover
2.