Prepare the hood – Broan ALLURE QS3 User Manual

Page 3

Advertising
background image

Page 3

ALLURE

®

QS3 SERIES

RANGE HOOD

PREPARE THE HOOD

4

Remove

Damper/Duct

Connector

from inside

the hood. Set

connector

aside - with

mounting

screws and

parts bag.

3

Remove

Teflon

®

-coated

bottom cover

from hood.

Set cover and

mounting screws

aside.

5

Remove either

top or back

wiring knock-

out and install

approved

Electrical

Cable Clamp.

DAMPER/

DUCT

CONNECTOR

ELECTRICAL CABLE CLAMP

TEFLON

®

-COATED BOTTOM COVER

(Held in place with 2 screws)

Teflon

®

is a registered

trademark of DuPont.

PREPARE THE HOOD

Non-Ducted Installation - Skip to Step 15.

6

Remove

Light Panel - held in place with (3) #8 screws

and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

(3) #8 SCREWS

LIGHT

PANEL

(2) #8 SCREWS

The following
Steps (6 thru
14) are for
DUCTED
INSTALLATION
ONLY.

BAFFLE

7

Remove

Air

Chute - held in

place with one

(1) screw.

NOTE: Be care-

ful not to discon-

nect any wires.

9

Rotate baffle. Re-

insert baffle into air

chute (as shown) so

that baffle

tabs fit all

the way into

slots in

air chute. An audible

“click” will be heard

when fully installed.

This will close off

the air flow through

the non-ducted slots

on top of hood.

10 Re-install air chute, re-connect wire

harness, and replace light panel.

NOTE: Be careful not to trap wires

between

support fin and light panel.

AIR CHUTE

SLOTS

8

Remove

Baffle

from air chute.

BAFFLE

SUPPORT FIN

TABS

Advertising