Anbringung und entfernung des objektivschutzen, Bringen sie den blitz an der kamera an, Advance check of the case – Olympus PTEP11 User Manual

Page 12: Advance check before use, Remove the o-ring, Remove any sand, dirt, etc

Advertising
background image

EN 11

EN

2. Advance check of the Case

Advance check before use

This Case has been the subject of thorough quality control for the parts during the manufacturing
process and thorough function inspections during the assembly. In addition, a water pressure test is
performed with a water pressure tester for all products to confirm that the performance conforms to the
specifications.

However, depending on the carrying and storage conditions, the maintenance status, etc., the
waterproof function may be damaged.
Before using, always perform the following advance checks.

Remove the O-ring

Open the Case (lens port) (P.13) and remove the O-ring.

Procedure

1

Insert the O-ring remover into the gap between the O-ring and O-ring groove wall.

2

Bring the tip of the inserted O-ring remover below the O-ring. (Be careful not to damage the groove
with the tip of the O-ring remover.)

3

Lift the O-ring, pinch it with your fingertips and pull it out of the Case.

Remove any sand, dirt, etc.

After visually checking that dirt has been removed from the O-ring, check for attached sand and other
foreign matter, as well as for damage and cracks by squeezing the entire circumference of the O-ring
lightly with your fingertips.
Remove attached foreign matter from the O-ring groove with a clean cloth or a cotton swab. Also remove
any sand or dirt attached to any part of the Case that comes into contact with the O-ring.

CAUTION:

If the advance test should show water leakage with normal handling, stop using the Case and contact your
dealer or an Olympus service station.

CAUTION:

• When a sharp object is used to remove the O-ring or to clean the inside of the O-ring groove, the Case and

the O-ring may be damaged and water leakage may be caused.

• When the O-ring is checked with the fingertips, take care not to stretch the O-ring.
• Never use alcohol, thinner, benzene or similar solvents or chemicals detergents to clean the O-ring. When

such chemicals are used, it is likely that the O-ring will be damaged or that its deterioration will be

accelerated.

PT-EP11_EN.Book Page 11 Friday, November 22, 2013 10:54 AM

Advertising