Olympus PT-EP10 - Manual (Page 17)

EN 16
EN
4. Connecting the underwater flash
To connect the UFL-2 underwater flash (optional) to the Case using an underwater optical fiber cable
(optional: PTCB-E02), follow the procedures below.
Setting of the digital camera
Set the RC mode of the camera to ON so that the camera's built-in flash is activated.
In case of UFL-2, turn the RC mode to ON.
For details, refer to the instruction manual of UFL-2.
In case of UFL-1, plug the optical fiber cable in the same way.
Turn the RC mode of the camera to OFF.
Connecting the underwater optical fiber
cable
1 Put the underwater optical fiber cable plug into
the optical fiber cable insertion slot.
Insert firmly until it stops next to the flash window
cover.
2 Put the cap to the optical fiber cable insertion slot
when not in use.
PT-EP10_EN.Book Page 16 Thursday, September 20, 2012 5:44 PM