Baby Trend SERENGETTI 1956CT - Manual (Page 3)

1. Carefully remove stroller from the carton. Note: Front wheels, rear
wheels, child tray and parent tray MUST be installed before using.
2. Unfold stroller frame by sliding the RED thumb trigger to the left and
squeezing the RED pull trigger while pulling backward on the stroller
handle. (Fig. 1-2)
3. To attach the front wheels, lean the stroller back so that it rests on the
handle with the front and rear legs pointing upward. Position the front
wheels over the front leg tubes so that the hole in the housing lines
up and will slide onto the legs. (Fig. 3) Firmly push down until the
wheels lock securely into place. Tug on each wheel to ensure they are
both securely attached.
4. Attach the rear axle assembly and wheels as follows:
a. Position axle assembly over the rear leg tubes, brake pedals
facing the back. At the same time, push down applying equal
pressure to both sides until they lock into place. (Fig. 4)
b. Slide a wheel onto each side of the axle. (Fig. 5)
c. Secure both wheels using with a locking washer. Push locking
washer firmly in place. (Fig. 6a)
d. Cap axle end using the solid metal caps. (Fig. 6b)
e. Cover and finish using hubcaps. (Fig. 6c)
Pull on both wheels to ensure they are secure and can spin freely.
Note:
DO NOT use stroller if wheels do not lock into place. If you
need assistance, please contact our customer service department at
(800) 328-7363, M-F, between 8am and 4:30pm, PST.
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE
FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE
INSTRUCTIONS FOR FUTURE REFERENCE.
Fig. 3
PARTS
TO ASSEMBLE STROLLER
Child Tray
Solid Cap (2)
Locking Washer (2)
Rear Wheel (2)
Stroller
Fig. 1
Flex-Loc Base
Car Seat
Fig. 2
Rear Axle Assembly
Hub Cap (2)
Front Wheel (2)
3
Fig. 4
Parent Tray
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Fig. 5
c b a