Olympus PT-054 - Manual (Page 18)

EN 18
EN
Seal the Case
1 Close the Case gently while aligning the mounting projection of the rear lid
and groove.
2 Turn the open/close dial clockwise until lock.
• The Case is sealed.
3 Slide the lock knob towards the LOCK side.
Check the operation of the loaded camera
After sealing the Case, check that the camera operations normally.
1 Push the ON/OFF button on the Case and confirm that the camera
turns ON/OFF.
2 Press the shutter lever on the Case and confirm that the camera
shutter releases.
• Also operate other control buttons on the Case and confirm that the
camera functions properly.
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This
will cause water leakage.
• Close the rear lid of the Case so that the lens cap or LCD hood strap
doesn’t catch. If it catches, water leaks may result.
2
3
Close
PT-054_EN.book Page 18 Tuesday, September 11, 2012 7:02 PM