Bulldog Security INSTALLATION GUIDE OWNER'S GUIDE User Manual
Page 3
REMOTE CONTROL STARTER
CONTENTS
26
RS700
3
ATTENTION:
We urge you to immediately place this card in your wallet.
PROGRAMMING FUNCTIONS
FOR YOUR WALLET OR GLOVE BOX
WARRANTY VALIDATION
Mail to: JBS Technologies
225 Technology Way • Steubenville, OH 43952
PLEASE FILL OUT THIS FORM
AND MAIL IT IN TO REGISTER YOUR WARRANTY
Your Name ________________________________________
Address ________________________________________
________________________________________
Email Address _________________________________
Dealer Name ____________________________________
Address ________________________________________
________________________________________
Date of Purchase ___/___/___ Model # __________
Make/Model of Car ______________________________
Year of Car _____ V.I.N. # ____________________
Final Quality Check By _________________________
Protected by one or more
of the following patents:
Patent #08528768
Patent #5477090
Patent #55459447
Patent #5677664
Patent #60087174
Patent #60097821
Patent #5886622
Patent #5942988
Other patents pending.
Adding Additional Remotes Press and hold brake. Next, press and hold Button
#1 on the working remote until the parking lights flash once. Release.
Press and release Button #4 on the new remote. The parking lights will
flash three (3) times confirming that the new remote was learned. Cold
Start On and Off (Degree Select) Press and hold brake. Press and hold
Button #2 until the parking lights flash twice. Release. Press and hold
Button #2. Each parking light flash is a progression in degrees. Flash
#1 is -40ºF, flash #2 is -30ºF, flash #3 is -20ºF, flash #4 is -10ºF, flash
#5 is 0ºF, flash #6 is +10ºF, flash #7 is +20ºF. Two quick parking light
flashes is Cold Start Off. Release the brake, the parking lights will flash
three (3) times. NOTE: Factory setting is OFF. Tach Mode - ON
Press and hold brake. Press and hold Button #3, the parking lights will flash
three (3) times. Release. Press and release Button #4, the parking lights
will flash twice. The Tach Start is programmed ON. Release the brake, the
parking lights will flash three (3) times. Tachless Mode - ON Press and
hold brake. Press and hold Button #3, the parking lights will flash three
(3) times. Release. Press and release Button #4, the parking lights will flash
once. The Tachless Start is programmed ON. NOTE: Factory setting is Tachless
Start ON. Release the brake, the parking lights will flash three (3)
times.Programming Runtime with Brake not Pressed Press and hold Button #4.
The parking lights will flash once for every five (5) minutes you want to
program. Release button at desired runtime. Maximum length, 15 minutes.
System Features ..........................
4
System Components........................
5
Required Tools ...........................
5
Technical Assistance ....................
5
Before You Begin.......................
5-6
Precautions ..............................
6
Testing Your Wires.......................
7
Making Connections ....................
7-8
Locating & Making Connections .......
9-11
Neutral Safety Switch ..................
12
Connecting 18-Pin Harness..............
13
Connecting 4-Relay Harness.............
13
Antenna Placement.......................
14
Anti-Theft System.......................
14
Optional Connections ................
15-18
Operator Programming Instructions..
18-19
How to use Your Remote Transmitter ....
20
Vehicle Anti-Theft Chart............
21-24
FCC ID Notice ...........................
24
Important Functions .................
25-26
Warranty Validation ....................
26
Your Warranty ...........................
27