Beverage-Air GRINDMASTER 3311 - Manual (Page 4)

OPERATOR’S SAFETY PRECAUTIONS
IMPORTANT: Failure to comply with the following safety precautions may result in severe personal injury or damage
to the machine.
1. Read and understand the operating instructions in this manual thoroughly. Only allow properly trained persons to
operate this machine.
2. Note all warning labels on the freezer. If any warning labels are missing or damaged replace them immediately.
3. Do not wear loose fitting garments or jewelry which could cause a serious accident.
4. Stay alert at all times during operation.
5. Keep operating area clean.
6. Do not attempt any repairs unless the main power supply to the freezer has been disconnected. Contact
Grindmaster Technical Service for service assistance.
7. Do not put objects or fingers in the dispense plunger.
8. Do not operate freezer if any excessive noise or vibration occurs. Contact your authorized service agent.
9. Be certain machine is installed with adequate space for proper air circulation. (See installation section.) Failure to
provide sufficient ventilation will reduce freezer performance and void equipment warranty.
Located on the right, left and rear panels. (part # W0600218)
FREEZER APPLICATION AND SPECIFICATIONS
Model 3311
The freezer consists of a freezing cylinder with a rotating internal auger (dasher) that is belt-driven by an electric
motor. The auger scrapes frozen product off of the inside of the refrigerated cylinder. A torque sensing mechanism
controls compressor operation to maintain desired product consistency. The freezer utilizes either an air-cooled or
water-cooled refrigeration system to freeze the product. A self-closing dispensing valve is attached to the front of the
freezing cylinder. The unit has an adjustable consistency control and an out of product indicator.
When properly operated and cared for, the Model 3311 will provide many years of service. Proper care includes
regular cleaning and maintenance. To minimize the amount of maintenance necessary, follow the operating
procedures outlined in this manual.
Product Tips
The Model 3311 was designed to dispense a wide variety of frozen beverages including frozen fruit juice, frozen
lemonade, slush and frozen cocktails. These products can be served in consistencies ranging from thin to fairly
thick.
Two types of dispensing valve plungers and product consistency springs are available depending on the thickness of
the product being served. These parts are interchangeable depending upon your needs. One plunger, part
W0480438 has one horizontal outlet slot and is used to serve thin to medium products such as frozen lemonade and
slush. The other plunger, part W0480451 has two horizontal outlet slots and is used to serve thicker product such as
neutral base frozen cocktails. A red spring, part W0631239, is used on the drive motor to adjust product consistency
to serve thin to medium products. The yellow spring, part W0631238, is used for thicker product. The spring is locat-
ed next to the drive motor behind the right hand side panel.
Over an extended period of time, some products, such as frozen cocktails that contain alcohol, have a tendency to
separate, or stratify. Separation of product on the mix storage hopper can result in frozen product quality inconsis-
tency. Simply keeping the product, in the mix storage hopper, stirred on a regular basis will eliminate this problem.
Page 2 Model 3311