Scarlett SC-1160 - Manual (Page 4)

www.scarlett-europe.com SC-1160/61/62 4
· Operating unit should be far away from the flammable or easy bulging under high
temperature objects.
CAUTION:
· To avoid a circuit overload, do not operate another high wattage appliance on the same
circuit.
· Do not cover the appliance when in use.
ASSEMBLING
· Assemble wheel couples as shown at the picture.
· Fasten them with two screws enclosed.
· Fit wheels to the oil heater body.
USING THE APPLIANCE
· Set thermostat to minimal position with power switch at Off position, and then plug in the
appliance.
POWER SELECTOR
· You can adjust oil heater current power using power regulator:
Off;
Minimal power;
III Maximum power.
THERMOSTAT
· Set thermostat to maximum position.
· When the temperature rises to satisfying level, slowly turn the thermostat counterclockwise
until the indicator lights is out, and the room temperature thus can keep constant.
· If you want to change the room temperature, you can make another regulation: turn the
thermostat clockwise to arise the temperature and counterclockwise to lower it.
NOTES:
· The room must be properly sealed, if not, using of oil heater will not make good result
because of heat leakage.
· After use, turn the power selector to the 0 position, then turn the thermostat to the MIN
position and unplug from power supply.
CLEAN AND CARE
· The oil heater should be cleaned regularly to wipe out the dust on the surface of fins. As this
may result the radiating efficient.
· Unplug from the power supply and allow the appliance to cool down.
· Wipe out with a soft damp cloth. Do not use detergent or abrasives.
· Do not scrap the surfaces of fins with sharp hard tools, to avoid surfaces getting rusty,
because of damage of the paint coat.
STORAGE
· Switch off and unplug the appliance. Ensure the oil heater is completely cool.
· Complete all requirements of chapter CLEAN AND CARE.
· Reel on the power cord.
· Keep the appliance in a dry cool place.
RUS
·
.
,
.
· ,
, , .
· .
.
· .
· .