Pioneer X-SMC5-K - Manual (Page 36)

Changing the settings 13
36
En
Network setting
If a broadband router (with built-in DHCP server function) is
connected to this unit, you can simply turn on the DHCP
server function without having to set up the network
manually. A broadband router without a DHCP server
function connected to this unit must be set up as described
below. Before you set up the network, consult with your ISP or
the network manager for the required settings.
It is advised that you also refer to the operation manual
supplied with your network component.
• Any changes made to a router without the DHCP server
function must be reflected to unit network settings.
1 Press SET UP.
The Initial Setup screen is shown on the main display.
2 Select Network Setting  Network
Configuration.
3 Use
/ to select Wired Setting or Wireless
Setting, then press ENTER.
Next steps are described separately between Wired Setting
and Wireless Setting. Follow the instructions of the
appropriate network type.
Wired Setting
1 Use / to select DHCP Off, then press
ENTER.
The IP address setting screen is displayed.
2 Use /// or number buttons to adjust
the numbers, then press ENTER.
• /: Moves the adjusting digit.
• /: Increases or decreases values.
Static IP Address
The IP address to be entered must be defined within the
following ranges. If the IP address defined is beyond the
following ranges, you cannot play back audio files stored
on components on the network or listen to Internet radio
stations.
Class A: 10.0.0.1 to 10.255.255.254 / Class B: 172.16.0.1
to 172.31.255.254 / Class C: 192.168.0.1 to
192.168.255.254
Subnet Mask
If an xDSL modem or a terminal adapter is directly
connected to this unit, enter the subnet mask listed in
your ISP documentation. In most of the cases, enter
255.255.255.0.
Gateway Address
If a gateway (router) is connected to this unit, enter the
corresponding IP address.
Preferred DNS/Alternate DNS
If there is only one DNS server address listed in your ISP
documentation, enter Preferred DNS. In case there are
more than two DNS server addresses, enter Alternate
DNS in the other DNS server address field.
Proxy Setup
Select Use Proxy Server when you connect this unit to
the Internet via a proxy server. Enter the IP address of
your proxy server in the Proxy Server Address field.
Also, enter the port number of your proxy server in the
‘Proxy Port’ field.
Wired Setting
Wireless Setting
Network Configuration
Static IP Address
192 . 168 . 2 . 4
X-SMC5_SYXZT8_En.book 36 ページ ２０１１年７月２８日 木曜日 午後３時２７分