Connecting the input/output terminals, Rear panel, front panel – Pioneer DJM-250-W User Manual
Page 6
6
En
Connecting the input/output terminals
! When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit’s
input terminals and in the settings of the input selector switches.
Also refer to the operating instructions of the DJ software and audio interface.
Rear panel, front panel
Audio output
section
Audio input
section
ON
DC IN
L
L
LINE
PHONO
PHONO / LINE
CD
CONTROL
SIGNAL
GND
R
L
3 COLD
2 HOT
1GND
R
R
L
PHONO / LINE
CD
CONTROL
R
L
R
1
2
3
OFF
CH-1
AUX
MASTER 1
MASTER 2
MIC
LINE
PHONO
CH-2
AUDIO
OUT
R
L
CONTROL
USB
To power outlet
Audio cable
Audio cable
Audio cable
Audio cable
Audio cable
Audio cable
Audio cable
To ground wire
terminals
Microphone
Microphone cable
To microphone
Analog player
DJ player
AC adapter
(included)
R
L
To audio output
terminals
Portable audio
device
To audio output
terminals
To audio output
terminals
To audio output
terminals
To audio input terminals
Powered speaker, component,
amplifier, etc.
R
R
R
L
R
L
Ground wire
R
L
Computer
Control cord 1
synthesizer
INPUT
1
2
3
4
EQ
POWER
INPUT
1
2
3
4
EQ
POWER
Example:
CDJ-350
L
L
Headphones
cord
Headphones
Rear panel
Front panel
1
To use the fader start function, connect a control cord (page 11).
The fader start function can only be used when connected to a Pioneer DJ player.
Cord hook
Loosen the cord hook’s screw and pinch the AC adapters’
power cord under the hook.
DC IN
L
R
R
MASTER 2
AC adapter’ s power cord
Cord hook
! Place the cord hook out of reach of children. If a child should
swallow it, contact a physician immediately.