Pioneer VSX-423-S - Manual (Page 20)

Basic Setup (VSX-423 only) 3 3
20
4
37
6
4
Press on the remote control, then press the
HOME MENU button.
The Home Menu appears on your TV. Use /// and
ENTER on the remote control to navigate through the
screens and select menu items. Press RETURN to exit
the current menu.
• Press HOME MENU at any time to exit the Home
Menu. If you cancel the Auto MCACC setup at any
time, the receiver automatically exits and no settings
will be made.
• The screensaver automatically starts after three
minutes of inactivity.
5
Select ‘Auto MCACC’ from the Home Menu, then press
ENTER .
• Mic In! blinks when the microphone is not connected
to MCACC SETUP MIC jack.
Try to be as quiet as possible after pressing ENTER . The
system outputs a series of test tones to establish the
ambient noise level.
6
Follow the instructions on-screen.
• Make sure the microphone is connected.
• Make sure the subwoofer is on and the volume is
turned up.
• See below for notes regarding background noise and
other possible interference.
7
Wait for the test tones to finish.
A progress report is displayed on-screen while the
receiver outputs test tones to determine the speakers
present in your setup. Try to be as quiet as possible while
it’s doing this.
• For correct speaker settings, do not adjust the volume
during the test tones.
8
Confirm the speaker configuration.
The configuration shown on-screen should reflect the
actual speakers you have.
• With error messages (such as Too much ambient
noise
) select RETRY after checking for ambient noise
(see Other problems when using the Auto MCACC
setup below ).
If the speaker configuration displayed isn’t correct, use
/ to select the speaker and / to change the
setting. When you’re finished, go to the next step.
If you see an error message (ERR) in the right side
column, there may be a problem with the speaker
connection. If selecting RETRY doesn’t fix the problem,
turn off the power and check the speaker connections.
9
Make sure ‘OK’ is selected, then press ENTER .
If the screen in step 8 is left untouched for 10 seconds
and ENTER is not pressed in step 9, the Auto MCACC
setup will start automatically as shown.
A progress report is displayed on-screen while the
receiver outputs more test tones to determine the
optimum receiver settings for channel level, speaker
distance, and Acoustic Calibration EQ.
Again, try to be as quiet as possible while this is
happening. It may take 1 to 3 minutes.
10
The Auto MCACC setup has finished! You return to the
Home Menu.
The settings made in the Auto MCACC setup should give
you excellent surround sound from your system, but it is
also possible to adjust these settings manually using the
Home Menu (starting on page 33 ).
Note
• Depending on the characteristics of your room, sometimes
identical speakers with cone sizes of around 12 cm will end
up with different size settings. You can correct the setting
manually using the Speaker Setting on page 33 .
• The subwoofer distance setting may be farther than the
actual distance from the listening position. This setting
should be accurate (taking delay and room characteristics
into account) and generally does not need to be changed.
RECEIVER
H o m e M e nu
1 . Auto MCACC
2.Manual SP Setup
3.Input Assign
4.Auto Power Down
5.HDMI Setup
R e t u r n
1.Auto MCACC
Now Analyzing
Environment Check
Ambient Noise
Speaker YES/NO
Cancel
1.Auto MCACC
Check!
OK
Return 10:Next
Front
Center
Surround
Subwoofer [ YES ]
[ YES ]
[ YES ]
[ YES ]
1.Auto MCACC
Now Analyzing
Surround Analyzing
Speaker System
X.Over
Speaker Distance
Channel Level
Acoustic Cal EQ
Return