03 controls and displays, Rear panel front panel, Controls and displays – Pioneer SX-20-S User Manual
Page 7: Controls and displays 03, Chapter 3, Rear panel, Front panel
Controls and displays
03
7
En
Chapter 3:
Controls and displays
Rear panel
See pages 5-6 for details regarding connections.
1
SIGNAL GND (Turntable ground)
terminal
This ground terminal is designed to help reduce noise
when a turntable is connected. It is not a safety ground.
2
ANTENNA terminal
Connect supplied FM wire antenna and AM loop
antenna.
3
PHONO (MM) IN terminals
4
SACD IN terminals
5
NETWORK IN terminals
6
RECORDER IN/OUT terminals
7
SPEAKERS A terminals
8
SPEAKERS B terminals
9
AC IN jack
Connect power cord to here and an AC wall socket.
AC IN
SPEAKERS
RECORDER
IN
IN
IN
L
R
IN
AM LOOP
SIGNAL
GND
FM UNBAL
75
OUT
PHONO (MM)
ANTENNA
SACD/CD NETWORK
B
R
L
R
L
A
2
3
4 5 6
1
8
9
7
Front panel
1
/I STANDBY/ON button
Switches the receiver between off and on.
When power is turned on, the power indicator in the
center of the button will lights blue.
2
STANDBY indicator
When power is set to standby, the indicator lights red.
3
Character display
See Display on page 8.
4
Remote sensor
Receives the signals from the remote control (page 4).
5
PHONES jack
Use to connect headphones. Be sure to switch off both
A and B speakers.
6
SPEAKERS A/B buttons
These buttons allow you to select various combinations
of speakers as follows:
• To drive A speakers, press SPEAKERS A button
(SPK A is displayed).
• To drive B speakers, press SPEAKERS B button
(SPK B is displayed).
• To drive both A and B speakers, press SPEAKERS A
and B buttons in order (SPK A B is displayed).
• When using headphones for private listening, press
these buttons in order to switch off the speakers A
and B (SPK OFF is displayed, and H indicator
lights).
7
Input function buttons
Use to select the input source to this receiver (page 9).
8
TONE DIRECT button
Press to select the TONE DIRECT mode (page 12).
9
Tuner control buttons
MEMORY
– Press to store preset stations.
TUNE/PRESET
– Press to select the tuning mode or
the preset mode.
10 Sound control buttons
TONE
– When adjusting the tone (bass and treble),
press to select the desired tone mode.
• Each time this button is pressed, the tone mode
is changed to bass or treble.
BALANCE
– When adjusting the sound volume
balance, press to enter the balance mode.
11
/– and +/ buttons
At the tuning mode, use to find radio frequencies.
At the preset mode, use to select preset radio stations.
Also used when setting up the receiver.
12 VOLUME control
Use to adjust the volume level. (Also allows adjustment
of the headphone sound volume.)
STEREO RECEIVER
VOLUME
TUNE / PRESET
MEMORY
STANDBY
A SPEAKERS B
PHONES
TONE
BALANCE
SX-20
STANDBY ON
1
4
5
2
3
6
7
8 9 10 11
12