Pioneer S-3EX-QL - Manual (Page 6)

6
En
Installation and Placement
How to install
This speaker system is supported by three points (the front two
legs, and the back spike located between the back two legs).
1 Choose the location for speaker placement then put the
spike bases on the floor.
2 Place the speaker on top of the spike bases.
3 If either the left or right back legs touches the ground
before the back spike, resulting in the speaker not resting
flat on its placed surface, adjust the back spike so it extends
to the ground before either of the back legs.
4 Place the included mounting pads underneath the back
legs to keep the speaker stable.
Choose the most appropriate thickness of mounting pad from the
several types included.
Mounting the Fall-Prevention Fastener
• Using the included screw, tightly secure the metal catch to the
backside of the speaker.
• Pass a commercially-available reinforced string through the
metal catch to securely support the speaker to the wall. Be
sure that the wall to which you fasten the speaker is strong
enough to support the weight of the speaker. After fastening
the speaker, make sure that it does not fall over.
• The speaker can incur damage in the event of a fall.
• Do not attach the metal catch directly to the wall. It should
only be used in conjunction with reinforced string to prevent
the speaker from falling.
• Pass two reinforced strings through the metal catch, and
fasten the speaker to the wall as shown above.
Do not place the speaker where it will be in direct
sunlight, and avoid positioning it near heaters and air
conditioners. Doing so may cause warping and
discoloration of the speaker cabinet and damage to
the speaker.
Pioneer assumes no liability whatsoever for
damages resulting from assembly, improper
mounting, insufficient reinforcement, misuse of the
product, acts of nature, etc.
• Do not place the speaker on an unstable surface. It could present a hazard if it falls, as well as damaging the equipment.
• As a precautionary measure, be sure to not place the unit anywhere where it might fall on a sleeping individual in the event of an
earthquake.
• As this unit weighs some 48 kg, it is very dangerous to try and set the spike nut while tilting the speaker. Be sure to place the unit on a
soft area (such as a blanket) so that it does not damage the floor, and carry out the installation with at least two people.
Legs
Cabinet base
Nut (for spike)
Back spike
Front
Back
Mounting pad
Backside of speaker
Sufficiently thick cord
Metal catch
S-3EX_EN.book 6 ページ ２００７年４月２３日 月曜日 午後５時１２分