Pioneer DEH-P800BT - Manual (Page 51)

Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :F.Range) or subwoo-
fer ( Rear SP :S/W) connection. If you switch
the rear output setting to Rear SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :F.Range).
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select
S/W control.
3 Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL will switch be-
tween Rear SP :F.Range (full-range speaker)
and Rear SP :S/W (subwoofer) and that status
will be displayed.
# When no subwoofer is connected to the rear
output, select
Rear SP :F.Range (full-range speak-
er).
# When a subwoofer is connected to the rear
output, select
Rear SP :S/W (subwoofer).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
46).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE
or ATT are displayed and no audio adjust-
ment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select Mute.
3 Press MULTI-CONTROL to switch the tel-
ephone muting/attenuation.
Pressing
MULTI-CONTROL will switch be-
tween TEL ATT (attenuation) and TEL mute
(muting) and that status will be displayed.
Switching the feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 48.
2 Use MULTI-CONTROL to select
Demonstration.
3 Press MULTI-CONTROL to turn the fea-
ture demo on.
# To turn the feature demo off, press
MULTI-CONTROL again.
Notes
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
Operating this unit
En
51
English
Section
02