Pioneer AVIC900HVT - Manual (Page 25)

25
24
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
ENG/MASTER 96
Installing the holders and the steering remote control
Note:
• When the unit is installed on a right-hand-drive car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
with belt.
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
2. Cut the extra portion of the belt at
the center of the inner holder.
3. Install outer holder on the inner
holder and secure with screws.
• Tighten the screws with the supplied hexago-
nal wrench.
4. Install the remote control unit in
the holder.
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.
Inner holder
Belt
Screw
Outer holder
Release Section
CRD3803A_inst_001_029_UK 4/1/03 2:22 PM Page 25