Pioneer PDP-S64 - Manual (Page 4)

English
4
2. Screw an supplied screw into the
speaker mounting hole (lower of the
two) at the top, rear of the flat screen
TV.
Do not tighten it all the way yet. Leave it loose, with
about 5 mm left to tighten.
����
��������
���������
����
�������������
��������������
���������������������
���������������������������
3. Hang the speaker bracket on the
screw you installed at the top by
passing the wide part over it and
lowering into the slot; screw in the
lower screw temporarily.
After passing the wide part of the hole of the speaker
bracket (top) over the screw, lower the speaker onto it.
��������������������������
�������������������������
���������������������������
��������������������������
��������
������������������
�����������������
���������������������
������������������
4. Adjust the position of the speaker
and then tighten the upper and lower
screws firmly.
5. Tighten the two screws, at the top
and bottom for each speaker (total of
four screws), thus fixing the speakers
to the flat screen TV.
6. Pass the supplied speaker cable
between the speaker and the flat
screen TV (below the speaker bracket)
from below.
7. Connect the speaker cables to the
speaker (see next page).
8. Insert the cable in the groove on the
speaker.
�������������
��������
��������
����������
���������
9. Connect the other end of the speaker
cables to the rear of flat screen TV (see
next page).