Pioneer X-HM20DAB-K - Manual (Page 10)

11/8/11 X-HM10_20_DAB_En.fm
En-10
Setting the clock (Remote control
only) (continued)
To confirm the time display:
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
Note:
When power supply is restored after unit is plugged in again
or after a power failure, reset the clock (page 9).
To readjust the clock:
Perform “Setting the clock” from step 1. If the “Clock” does not
appear in step 2, step 4 (for selecting the 24-hour or 12-hour
display) will be skipped.
To change the 24-hour or 12-hour display:
Note:
The timer setting will reset if the power cord is pulled out
or when there is a blackout.
Listening to the iPod, iPhone or iPad
(X-HM20DAB only)
Supported iPod, iPhone and iPad models:
l
iPad
l iPhone 4
l iPhone 3GS
l iPhone 3G
l iPhone
l iPod touch (4 th generation)
l iPod touch (3 rd generation)
l iPod touch (2 nd generation)
l iPod touch (1 st generation)
l iPod classic
l iPod nano (6 th generation)
l iPod nano (5 th generation)
l iPod nano (4 th generation)
l iPod nano (3 rd generation)
l iPod nano (2 nd generation)
Notes:
l
This system has been developed and tested for the
software version of iPod/iPhone/iPad indicated on the
website of Pioneer (http://pioneer.jp/homeav/support/
ios/eu/).
l Installing software versions other than indicated on the
website of Pioneer to your iPod/iPhone/iPad may result
in incompatibility with this system.
l Charging terminal for iPod, iPhone and iPad:
l The message “This accessory is not made to work with
iPhone” or similar, may appear on the iPhone screen
when:
- battery is low.
- the iPhone is not properly docked (eg. slanting).
if this occure, remove and re-dock the iPhone.
l This product is made for iPhone. To prevent random
interference when iPod/iPhone is docked, the
headphone output is disabled and "HP INVALID" will
be displayed.
You may also experience brief audio interference
during incoming calls.
1 Press the STANDBY/ON button to turn the power on.
2 Press the USB button on the remote control or INPUT
button repeatedly on the main unit to select USB
function.
3 Connect iPod, iPhone or iPad to the unit. "iPod" will
appear.
4 Press the / (CD/USB / ) button to start playback.
Note:
Stop button ( ) is invalid during iPod, iPhone or iPad
playback.
4 Press the or button to select 24-hour or 12-
hour display and then press the ENTER button.
The 24-hour display will appear.
(00:00 - 23:59)
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
5 To adjust the hour, press the or button and then
press the ENTER button. Press the or button
once to advance the time by 1 hour. Hold it down to
advance continuously.
6 To adjust the minutes, press the or button and
then press the ENTER button. Press the or
button once to advance the time by 1 minute.
1 Clear all the programmed contents. [Refer to “Factory
reset, clearing all memory” on page 26 for details.]
2 Perform “Setting the clock” from step 1 onwards.
Condition
Docking
station
USB terminal
USB function NO YES
Other function YES NO
Stand-by YES NO
n iPad connection (USB Terminal)
1 Insert the connector to the the iPod, iPhone or iPad.
2 Connect the iPad to the unit via USB connector.
Note:
USB connector do not support VIDEO out.
n iPod, iPhone or iPad Playback (USB
Terminal)