Pioneer XDV-P6 - Manual (Page 13)

13
English
Español
Deutsch
Français
Italiano
Nederlands
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame.
To remove the frame, extend top and bottom of the frame outwards in order to unlock it.
(When reattaching the frame, point the side with a groove downwards and attach it.)
• It becomes easy to remove the frame if the front panel is released.
2. Fastening the unit to the factory radio mounting bracket.
Select a position where the screw holes of the
bracket and the screw holes of the head unit
become aligned (are fitted), and tighten the
screws at 2 places on each side. Use either
truss screws (5
× 8 mm) or flush surface
screws (5
× 8 mm), depending on the shape of
the screw holes in the bracket.
Frame
Insert the supplied extraction keys into the
unit, as shown in the figure, until they
click into place. Keeping the keys pressed
against the sides of the unit, pull the unit
out.
Screw
Dashboard or Console
Factory radio mounting
bracket