Pioneer PDK-TS24 - Manual (Page 4)

4
En
The weight of a 50 inch Plasma Display is about 34.1 kg (75.2
lbs), that of a 42 inch model is about 29.0 kg (64.0 lbs), they
have no depth, and are unstable. Therefore, at least two
people must assemble and install them.
Note
Insert the bolts in the holes vertically and do not tighten
them with more force than necessary.
Place a sheet or protective cover to protect the display from
scratches or damage.
Assemble only with the Plasma Display lying flat on a table
or similar surface.
Move the stand so that the stand screw holes and the nuts
that connect the main display line up correctly.
1
With the Plasma Display lying flat, insert
and secure the two Installation bolts 2 (M8
x 20 mm: black) in the holes "a" located in
center of the Plasma Display housing.
At this point, tighten these bolts 2 only until the threads
are no longer visible when viewed from the side (you will
be unable to attach the display if the bolts are screwed in
completely).
Attaching the Plasma Display
Regarding the stand pipe screw holes when the
stand is used as a desktop stand
Table: Stand pipe screw holes when the stand is used as a
desktop stand
Plasma Display model
42 inch display model
50 inch display model(except under speaker models)
50 inch display model(under speaker models)
Screw holes used with
stand orientation
A, A'
B, B'
2
As shown in the above figure, hook the
stand pipe holes (either pipe A or B) onto
the screw heads of the installation bolts 2,
then slide the stand upwards to the main
Plasma Display until it engages the installa-
tion bolts 2 (once put together with the
display, the stand will slides no more than
19 mm (3/4 inch)).
3
Pass the installation bolts 3 (M8 x 40 mm:
black) through the stand pipes and tighten
the installation bolts firmly with the
accessory hexagonal wrench (The holes
should be used in the proper combinations,
A–A' and B–B').
4
Tighten the installation bolts 2 firmly with
the accessory hexagonal wrench.
Caution
Note
When laying down the Plasma Display, be careful so as to not
scratch or damage it.
B
A
B
´
A
´
B
A
B
´
A
´
Sheet
Plasma Display
Holes "a"
(holes in center of
Plasma Display)
Installation
bolt 2
Plasma Display
housing
Stop screwing
down the bolt
when the threads
are no longer
visible.
Installation bolt 2
(M8 x 20 mm: black)
Table top stand
Installation bolts 3
(M8 x 40 mm: black)
(Step 3)
Slide the stand
(Step 2)