Pioneer PDK-TS07 - Manual (Page 9)

9
En
English
Attaching the Plasma Display
The Plasma Display is heavy, has no depth, and is
unstable, so be sure to have at least two people assemble
and install it.
Note
Insert the bolts in the holes vertically.
Place a sheet or protective cover to protect the display
from scratches or damage.
Assemble only with the Plasma Display lying flat on a
table or similar surface.
1
With the Plasma Display lying flat, insert and
secure the two Installation bolts 1 (M8 x 20
mm) in the holes "a" located in center of the
Plasma Display housing.
At this point, tighten these bolts 1 only until the
threads are no longer visible when viewed from the side
(you will be unable to attach the display if the bolts are
screwed in completely).
Caution
Note
When laying down the Plasma Display, be careful so as to
not scratch or damage it.
Table. Regarding the stand pipe bolt holes when the stand is
used as a desktop stand
2
As shown in table, hook the stand pipe holes
(either A or B) onto the bolt heads of the
installation bolts 1, then slide the stand
upwards to the Plasma Display until it engages
the installation bolts 1.
It slides no more than 19 mm because of the structure
of the stand.
3
Pass the installation bolts 2 (M8 x 40 mm)
through the stand pipe holes (either A
’ or B ’ ),
and then screw them into the main Plasma
Display with the accessory hexagonal wrench.
The combinations of holes used are A – A’ and
B – B’.
Move the stand so that the stand screw holes and
the nuts that connect the main display line up
correctly.
Be sure to tighten the bolts securely.
4
Tighten the installation bolts 1 firmly with the
accessory hexagonal wrench.
Be sure to tighten the bolts securely.
Plasma Display
Installation
bolt
1
Plasma Display
housing
Stop screwing
down the bolt
when the threads
are no longer
visible.
Installation bolt 1
(M8 x 20 mm)
Sheet
Holes "a"
(holes in center
of Plasma
Display)
B
Installation bolts 2
(M8 x 40 mm)
(Step 3)
Slide the stand
(Step 2)
Table top stand
Plasma Display model Bolt holes used with stand orientation
50 inch display model B, B'
43 inch display model A, A'
42 inch display model A, A'
Note
C and C ’ indicate bolt holes for optional components that
are sold separately.