Pioneer DVH-P7000R - Manual (Page 12)

Installation with the rubber bush
Fig. 9
Holder
After inserting the holder into the
dash-board, then select the
appropriate tabs according to the
thickness of the dash-board
material and bend them.
(Install as firmly as possible using
the top and bottom tabs. To secure,
bend the tabs 90 degrees.)
182
53
Rubber bush
Screw
Dashboard
Installation
Notes
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all con-
nected up properly, and the unit and the sys-
tem work properly.
• Use only the parts included with the unit to
ensure proper installation. The use of unau-
thorized parts can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifi-
cations of the vehicle.
• Install the unit where it does not get in the
driver’s way and cannot injure the passenger
if there is a sudden stop, like an emergency
stop.
• The semiconductor laser will be damaged if it
overheats, so don’t install the unit anywhere
hot — for instance, near a heater outlet.
• If installation angle exceeds 30° from horizon-
tal, the unit might not give its optimum perfor-
mance. (
Fig. 7 )
Fig. 7
• The cords must not cover up the area shown
in the figure below. This is necessary to allow
the amplifires to radiate freely. (
Fig. 8 )
Fig. 8
Do not close this area.
En 12