Pioneer S-ES3TB - Manual (Page 3)

3
En
WALL-MOUNTING THE SURROUND
SPEAKERS
Before mounting
• Remember that the speaker system is heavy and that
its weight could cause the screws to work loose, or
the wall material to fail to support it, resulting in the
speaker falling. Make sure that the wall you intend to
mount the speakers on is strong enough to support
them. Do not mount on plywood or soft surface walls.
• Mounting screws are not supplied. Use screws
suitable for the wall material and support the weight
of the speaker.
SECURING THE FRONT SPEAKERS
• Pass a commercially-available reinforced string
through the plastic catch to securely support the
speaker to the wall. Be sure that the wall to which you
fasten the speaker is strong enough to support the
weight of the speaker. After fastening the speaker,
make sure that it does not fall over.
• The speaker can incur damage in the event of a fall.
• Do not attach the plastic catch directly to the wall. It
should only be used in conjunction with reinforced
string to prevent the speaker from falling.
Pass and tie two reinforced strings through the plastic
catches, and fasten the speaker to the wall as shown
above.
• If you are unsure of the quality and strength of the
walls, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.
CABINET MAINTENANCE
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth
dipped in some neutral cleanser diluted five or six times
with water, and then wipe again with a dry cloth. Do not
use furniture wax or cleaners.
Never use thinners, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will
corrode the surfaces.
ATTACHING / DETATCHING THE GRILLE
The front grille of this speaker system is removable.
Proceed as follows:
FRONT SPEAKERS
1. To attach the grille, line up the holes on the speaker
with the projections on the grille firmly.
2. To detatch the grille, grab it by its bottom with both
hands and toward you to separate the bottom part of
the grille from the speaker.
3. Slide your hands up the middle section of the grille,
and once again pull gently toward you. This will
remove the middle section of the grille from the
speaker.
4. Finally, repeat this same motion for the top part of the
grille, detatching the grille entirely from the speaker.
CENTER / SURROUNDS SPEAKERS
1. To detatch the grille, grab it by its bottom with both
hands and toward you to separate the bottom part of
the grille from the speaker.
2. Next, grab the top part of the grille and gently pull it
toward you to remove the top portion.
3. To replace the grille, align the holes in the front of the
speaker’s corners with the projections on the grille,
and push each of the corners into place.
TROUBLESHOOTING
5 mm to 7 mm
3.7 mm
9.3 mm
Mounting screw
(not supplied)
Plastic catches Reinforced strings
Backside of speaker
Symptom Possible cause Remedy
No sound • Bad speaker cord or
connection.
• Amplifier is off.
• Volume control is at zero. • Connect correctly or
replace cord.
• Turn on amplifier.
• Slowly turn up volume.
Sound is
distorted. • Extreme signal condition. • Turn down the
amplifier’s output level
(volume, bass control,
bass boost) to lower the
level.
S-ES3TB_En.fm 3 ページ ２０１０年６月４日 金曜日 午後１２時５０分