Pioneer PDP-S08 - Manual (Page 3)

3
English
English
INSTALLATION ON THE
PLASMA DISPLAY
Perform installation according to the following steps 1 to 7.
NOTE:
Before attaching the speaker, please attach the PDK-
TS01 table top stand (or another Pioneer plasma
display stand) to the plasma display unit.
1
Attach the speaker mounting fittings to
the rear of the plasma display.
Using the supplied hexagon socket head screws, fix
the speaker mounting fittings to the left and right
sides of the plasma display. (Use the supplied hex
wrench to tighten the screws.
• Turn clockwise to tighten.
• Align the lugs on the speaker mounting fittings
with the holes in the plasma display unit.
2
Connect the supplied speaker cords to
the back of the plasma display.
(Please also see the installation instructions of the
plasma display.)
3
Attach the two supplied wire clamps to
the rear of the speakers, as shown.
• The clamp opening should be pointing downward.
4
Connect the other end of the speaker
cords (see step 2) to the speakers.
See the following page for more detailed information
on connecting speaker cords.
5
Mount the speakers onto the speaker
mounting fittings.
To avoid damaging the stand, cover it with the
protective wrapping that covered the speaker.
Protective wrapping (the PDK-TS01 table top stand
only)
Carefully, mount the speaker onto the mounting
fittings.
6
Fix the speaker to the mounting fittings.
Use the supplied flat countersunk-head screws to fix
both right and left sides of the speaker to the
mounting fittings as shown below.
• Turn clockwise to tighten.
NOTE:
Do not use the screw hole located on the
underside of the mounting fittings to fix the
speaker.
This illustration
shows the PDK-
TS01 table top
stand.
This illustration
shows the PDK-TS01
table top stand.
This illustration shows
the PDK-TS01 table
top stand.