Pioneer S-FL1 - Manual (Page 3)

3
En
English
Installation
No stand or other fittings for mounting the speaker are
supplied. Please use appropriate fittings, screws, etc. in
order to install the speaker properly.
You will need a cross-head screwdriver or hexagonal
wrench for installation.
Note
• Please use screws suitable for the wall material and
strength. The following is a guide to the length of
screws you should use for the speaker and fittings:
• Do not overtighten the screws as this can cause
damage.
• To reduce the risk of the speaker falling or toppling
over should there be an accident, please reinforce
the mounting fittings for added safety.
Installation example 1 (horizontal
mounting)
1 Use the two screw holes on the longer side of the
speaker.
2 Use two screws with washers to attach the stand
or other fitting to the speaker.
Installation example 2 (vertical mounting)
1 Use the two screw holes on the shorter side of
the speaker.
Depth of mounting material +
washer + 7~15 mm
150 mm
16.5
19
5
Unit : mm
Screw holes
(M8 x P1.25)
Screw
Washer
150 mm
Screw holes
(M8 x P1.25)
01 speaker system.fm 3 ページ ２００５年８月３日 水曜日 午前１１時３５分