Calling the wake-up timer, Cancelling the wake-up timer, Using the wake-up timer – Pioneer X-CM31-R User Manual

Page 14: Using the sleep timer, Using headphones, Timer volume phones audio in ipad

Advertising
background image

Getting started

04

14

En

Calling the wake-up timer

It can be used to re-use an existing timer setting.

1

As well as steps 1 through 3 in “Setting the

wake-up timer”.

2

Press

/ to select “TIMER ON”, then press

ENTER.

Cancelling the wake-up timer

It can be used to turn off the timer setting.

1

As well as steps 1 through 3 in “Setting the

wake-up timer”.

2

Press

/ to select “TIMER OFF”, then

press ENTER.

Using the wake-up timer

1

Press

STANDBY/ON to turn the power

off.

2

At the wake-up time, this unit will turn on

automatically and play the selected input
function.

Note

• If at the wake-up time iPod/iPhone/iPad is not connected

to this unit or a disc is not inserted, this unit will be

turned to on and not play back the track.

• Some discs may not be played automatically at the wake-

up time.

• If you set the timer, take one minute or more between the

start and end time.

Using the sleep timer

The sleep timer switches off the unit after a specified time so

you can fall asleep without worrying about it.

1

Press SLEEP repeatedly to select a switch off

time.

Choose between 10 min, 20 min, 30 min, 60 min, 90 min, 120

min, 150 min, 180 min or OFF. The newly set value displays for

3 seconds, and then the setting is completed.

Note

• The sleep timer can be set by pressing SLEEP while the

remaining time is displayed.

Using Headphones

Connect to the jack plug of the headphones.
When the headphones are connected, there is no sound

output from the speakers.

• Do not turn the volume on to full at switch on and listen

to music at moderate levels. Excessive sound pressure

from earphones and headphones can cause hearing

loss.

• Before plugging in or unplugging the headphone,

reduce the volume.

• Be sure your headphone has a 3.5 mm diameter plug

and impedance between 16 Ω and 50 Ω. The

recommended impedance is 32 Ω.

• Audio from the iPod/iPhone/iPad cannot be heard via

the headphones connected to the unit. “HP MUTE” will

be displayed if you connect the headphones when the

iPod/iPhone/iPad function is selected.

TIMER

VOLUME

PHONES

AUDIO IN

iPad

X-CM31_SYXE8_En.book 14 ページ 2012年6月7日 木曜日 午後2時4分

YOM2001450001.pdf 14

2012/7/5 10:44:08

Advertising
This manual is related to the following products: