Pioneer DCS-414K - Manual (Page 22)

22 Installation
Installa
tion
3
HDMI Out Connection
If you have a HDMI TV or monitor, you can
connect it to this unit using a HDMI cable.
Connect the HDMI OUT jack on the unit to
the HDMI IN jack on a HDMI compatible TV or
monitor.
Set the TV’s source to HDMI (refer to TV’s
Owner’s manual).
HDMI Connection
TIP
You can fully enjoy digital audio and video
signals together with this HDMI connection.
NOTE
• If a connected HDMI device does not accept
the audio output of the unit, the HDMI device
’s audio sound may be distorted or may not
output.
• When you connect a HDMI or DVI compatible
device make sure of the following:
- Try switching off the HDMI/DVI device and this
unit. Next, switch on the HDMI/DVI device and
leave it for around 30 seconds, then switch on
this unit.
- The connected device’s video input is set
correctly for this unit.
- The connected device is compatible with
720x480i (or 576i), 720x480p (or 576p),
1280x720p,1920x1080i or 1920x1080p video
input.
• Not all HDCP-compatible HDMI or DVI devices
will work with this unit.
- The picture will not be displayed properly with
non-HDCP device.
- This unit does not playback and TV screen is
changed to black or green screen or the snow
noise may occur on the screen.
CAUTION
• Changing the resolution when the connection
has already been established may result in
malfunctions. To solve the problem, turn off the
unit and then turn it on again.
• When the HDMI connection with HDCP is not
verified, TV screen is changed to black or green
screen or the snow noise may occur on the
screen. In this case, check the HDMI connection,
or disconnect the HDMI cable.
• If there is noise or lines on the screen, please
check the HDMI cable (length is generally
limited to 4.5m) and use a High Speed HDMI
cable (Version 1.3).
DCS-414K(��).indd 22 2011-05-13 �� 7:25:15