Pioneer VSX-1014-S - Manual (Page 76)

Additional information 12
76
En
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Resetting the main unit
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button, press and
hold the STANDBY/ON button for about three
seconds.
3 When you see RESET? appear in the display,
press ENTER.
OK?
shows in the display.
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Changing the frequency step
If you find that you can’t tune into stations successfully,
the frequency step may not be suitable for your country/
region. Heres how to switch the setting:
1 Switch the receiver into standby.
2 While holding down the front panel BAND
button, press STANDBY/ON.
The display shows the new setting:
• 9K STEP – For areas with an FM reception of 50kHz
and AM reception of 9kHz
• 10K STEP – For areas with an FM reception of 100kHz
and AM reception of 10kHz
Note
• If you’re unsure of the correct frequency step for your
region, consult your local Pioneer dealer.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω impedance rating.
• With the receiver in standby, press STANDBY/
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω .
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Changing the TV format setting
VSX-1014-S model only
If the System Setup menu is not displayed correctly, it
may be that the TV system is set incorrectly for your
country or region.
• With the receiver in standby, press STANDBY/
ON while holding down the SIGNAL SELECT button.
The display shows the new setting ( PAL or NTSC ).
PQLS OFF This is displayed on a playback component when PQLS turns off during playback. The sound may be
interrupted momentarily when this happens.
PQLS ON This is displayed on a playback component when PQLS turns on during playback. The sound may be
interrupted momentarily when this happens.
UNKNOWN When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
the proper component name.
Message Explanation
12_additional_info.fm 76 ページ ２００４年８月１９日 木曜日 午前１１時２４分