Pioneer PDK-TS23 - Manual (Page 10)

10
En
Assembling the Stand
1
Turn the base cover over so the underside
is facing up.
Note
When the base cover is turned over, be very careful not
to scratch or damage the light-blocking shield.
2
Insert the stand pipes into the base cover.
3
Tighten the screws to stabilize the stand
pipes.
Note
Assemble the stand with a soft sheet placed under the base
cover.
If a sheet is not laid before assembly, the front surface of the
base cover may be scratched.
Base cover
Screws
(4 mm x 10 mm)
Stand pipe
Screws
(4 mm x 10 mm)
Stand pipe
Assembly Procedure
Attaching the Light-blocking Shield
2
While firmly holding the ends of the light-
blocking shield, apply it with the double-
sided adhesive tape.
Note
Be careful that the light-blocking shield does not catch on
the pipe insertion holes.
Anchor it in place so that there are no gaps (See diagram
at right). If there is a gap, the light-blocking shield may
peel off.
3
Anchor it in place while pressing it down
from above.
Sheet
Press
Press
Be sure that there
is no gap.