Pioneer DEH-P900HDD - Manual (Page 5)

Fig. 13
Abb. 13
Afb. 13
+
≠
+
≠
+
≠
+
≠
+
≠
+
≠
1*
2*
4*
3*
5*
32.
12.
15 cm
2. Antenna jack
15 cm 3. This Product
9. Subwoofer output
(SUBWOOFER OUTPUT)
10. Rear output (REAR OUTPUT)
11. Front output
(FRONT OUTPUT)
Note:
Depending on the kind of vehicle, the function
of 3* and 5* may be different. In this case, be
sure to connect 2* to 5* and 4* to 3*.
13. Connect leads of the same
color to each other.
14. Cap (1*)
When not using this terminal,
do not remove the cap.
15. Yellow (3*)
Back-up
(or accessory)
18. Red (5*)
Accessory
(or back-up)
16. Yellow (2*)
To terminal always supplied
with power regardless of
ignition switch position.
19. Red (4*)
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
20. Fuse resistor
20. Fuse resistor
17. Fuse holder
21. Orange/white
To lighting switch terminal.
22. Black (ground)
To vehicle (metal) body.
23. ISO connector
Note:
In some vehicles, the ISO connector may
be divided into two. In this case, be sure
to connect to both connectors. 24. Yellow/black
If you use a cellular telephone, connect it via the
Audio Mute lead on the cellular telephone. If not,
keep the Audio Mute lead free of any connections.
25. Speaker leads
White : Front left +
White/black : Front left ≠
Gray
: Front right +
Gray/black : Front right ≠
Green : Rear left +
Green/black : Rear left ≠
Violet
: Rear right +
Violet/black : Rear right ≠
26. Connecting cords with RCA
pin plugs (sold separately)
28. Blue/white
To system control terminal of the
power amp (max. 300 mA 12 V DC).
29. System remote control
30. Blue/white (7*)
To Auto-antenna relay control
terminal (max. 300 mA 12 V DC).
31. Blue/white (6*)
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 6* and 7*
when Pin 5 is an antenna control type. In another
type of vehicle, never connect 6* and 7*.
33. Left 34. Right
35. Front speaker 35. Front speaker
36. Rear speaker 36. Rear speaker
37. Subwoofer 37. Subwoofer
38. Perform these connections when using a
different amp (sold separately).
4. IP-BUS input (Blue)
15 cm
6. Multi-CD player
(sold separately)
5. IP-BUS cable
7. Power box
8. Power box cord
1 m
1. Auto-equalizing mike jack
1 m
27. Power amp
(sold separately)
27. Power amp
(sold separately)
27. Power amp
(sold separately)
Pull the auto-equalizing mike jack out of the
console box, so that the mike can be plugged
in or pulled out even after this unit has been installed.
Install the power box cord
securely so that the cord can not
be easily pulled out.
CRD3471A_inst 18-01-2002 10:24 Page 17